LILIBET 

32mm GAUGE ONLY 

£125 (including P&P within the UK - for international shipping contact us here) 

Boot Lane Works codename "LILIBET", this freelance model is inspired by locomotive builders, Manning Wardle, Neilson, etc.

Our 16mm kit is built from 3D printed filament & resin parts, and laser-cut acrylic and utilizes our new adaption to the Binnie Engineering 29mm wheel, creating an effective driving wheelset.
Together with printed rods, acrylic frames, etc, we can offer an economic, inside-framed power chassis.

It comes complete with a 3-6volt motor, nylon worm gears, Binnie Engineering 29mm wheels on 1/8" stainless steel axles, and all necessary metal stock, nuts, screws & washers required to build the model in the photos.

Also included in the kit is a micro slide switch (with a corresponding laser cut hole in the footplate) and a selection of resin-printed detail parts.

We do recommend access to a small "bench vice" to build this kit.

Building instructions are included with the kit.

Although not for beginners, the kit is reasonably easy to construct and requires basic tools, glue, paint and batteries to complete.

There is adequate room under the saddle tank for four “AA” batteries or a 3.7V Lipo battery (search eBay for "Syma X5C battery").
Batteries, Loco Remote or any electrics (except micro switch) are not included in the kit.

Model Dimensions - 

Width - 82mm

Length (over buffers) - 206mm

Height (from railhead to chimney top) - 114mm

Chassis Wheelbase - 56mm

Display model colours -
Halfords - Matt Black
Halfords - Rover Brooklands Green
Halfords - Red Oxide